KEPCO BOP 1KW-MG Operator Manual, Firmware Ver.2.01 to 2.37 - Manual (Page 87)

BOP HIPWR 022108
3-27
3.3.9.5 VIEWING STORED WAVEFORMS
After observing the precautions of PAR. 3.3.9.1, press @ from the power-up screen to access
the Saved Waveforms screen (Figure 3-9). Use
Y
or
U
or the encoder to highlight the name of
a previously saved waveform, then press ! to view the Waveform Settings screen (see Figure
3-10). The lower half of the LCD shows a representation of the programmed waveform. The let-
ters along the vertical axis of the graph at the lower left side indicate whether the waveform is
programmed to operate in voltage or current mode. The message at the upper right indicates
the actual mode of the power supply while the waveform is being executed. The upper half pre-
sents the waveform name, positive and negative protection settings, the repetition count, fol-
lowed by a listing of segments. The type (square, sine, etc.), frequency, p-p amplitude, and
whether the segment is initial (run only the first time) or repeating is indicated by I or R, respec-
tively. To see the offset, start/stop angle, initial/repeat for a segment, use
Y
or
U
or the
encoder to highlight the segment, then press ! (Initial/Repeat is not available for the last seg-
ment, since the last segment must repeat). Use use
Y
or
U
to highlight the parameter, press
! , then set the value or highlight the desired setting and press $ to save for power-up or %
to abort and exit without changing the parameter.
FIGURE 3-10. WAVEFORM SETTINGS MENU
3.3.9.6 EXECUTING A WAVEFORM
After observing the precautions of PAR. 3.3.9.1, press
@
from the power-up screen to enter
the Saved Waveforms screen (Figure 3-9). Highlight one of the stored waveforms, then press
!
. If the unit is in Standby, press the STANDBY key to turn the output on, then press
$
to
execute the waveform.
16.31Hz 21.7Hz 320 217.6Hz 261.0Hz 24
21.71Hz 27.1Hz 240 261.1Hz 435.0Hz 20
27.11Hz 32.6Hz 192 435Hz 652.5Hz 12
55.5Hz 66.5Hz 160 653 1000 10
NOTE: 1. As the frequency varies within the range, the time interval per point varies proportionately.
TABLE 3-10. SQUARE WAVEFORM FREQUENCY VS. POINTS
Frequency
(See Note 1) Total Points
Frequency
(See Notes 1) Total Points
From To From To
VOLTAGE
SOURCE