GW Instek GDS-1000A Series User Manual - Manual (Page 57)

MEASUREMENT
57
Moving the
horizontal
cursors To move the left cursor, press
X1 and then use the Variable
knob.
To move the right cursor, press
X2 and then use the Variable
knob.
To move both cursors at once,
press X1X2 and then use the
Variable knob.
Remove cursors Press Cursor to remove the
onscreen cursors. Cursor
Using the vertical cursors
Procedure 1. Press the Cursor key. Cursor
2. Press X↔Y to select the
vertical (Y1&Y2) cursor.
3. Press Source repeatedly to
select the source channel.
Range CH1, 2, MATH
4. The cursor measurement results will appear in
the menu.
Parameters Y1 Voltage level of the upper cursor
Y2 Voltage level of the lower cursor
Y1Y2 The difference between the upper and
lower cursor
V/A The voltage/current difference (Y1-Y2).