GW Instek GDS-1000A Series User Manual - Manual (Page 52)

GDS-1000A Series User Manual
52
FRF Time between:
Source 1 first rising edge and
Source 2 first falling edge
FFR Time between:
Source 1 first falling edge and
Source 2 first rising edge
FFF Time between:
Source 1 first falling edge and
Source 2 first falling edge
LRR Time between:
Source 1 first rising edge and
Source 2 last rising edge
LRF Time between:
Source 1 first rising edge and
Source 2 last falling edge
LFR Time between:
Source 1 first falling edge and
Source 2 last rising edge
LFF Time between:
Source 1 first falling edge and
Source 2 last falling edge
Automatic measurement gating
Background Automatic measurements can be restricted to a
specific area (gating). When cursors are turned on, the
area between the cursors is used for automatic
measurements. When cursors are turned off,
measurements are derived from all the points that are
displayed on screen.
Turn gating on 1. Turn on cursors to enable
gated automatic
measurements.
Page 56
2. Press the Measure key. Measure