GW Instek GDS-1000A Series User Manual - Manual (Page 123)

FAQ
123
F
AQ
• The input signal does not appear in the display.
• I want to remove some contents from the display.
• The waveform does not update (frozen).
• The probe waveform is distorted.
• Autoset does not catch the signal well.
• I want to clean up the cluttered panel settings.
• The accuracy does not match the specifications.
• The SD card slot does not accept my card.
• The oscilloscope will not allow a 2M waveform to be saved.
The input signal does not appear in the display.
Make sure you have activated the channel by pressing the CH key
(page43).
I want to remove some contents from the display.
To clear the math result, press the Math key again (page59).
To clear the cursor, press the Cursor key again (page56).
To clear the Help contents, press the Help key again (page42).