Yokogawa Button Operated DX2000 - Manual (Page 95)

3-34
IM 04L41B01-62EN
3.17 Attributes of Batch Name Components
(Can only be set with a Version 4.01 screen and a Version 4.11 screen)
The following restrictions apply to the attribute settings of batch name components.
• [Visible] can only be set when [Depend ID] is set to [None].
• When the Batch function is Off in the settings file, no attributes other than X, Y, Width,
and Height can be set.
• If the Batch function is On in the settings file, [Batch group no.] cannot be set.
• The MultiBatch number specified in the settings file is the maximum value for [Batch
group no.].
List of Settings
Refer to Section 3.3 for attributes without explanations in the list of settings.
Attribute Set value/choice
(Underlined items are initial
set values)
Description, conditions
X DX1000: 0 to 318
DX2000: 0 to 638 This is the X-coordinate of the left side of the component.
X = 0 for X < 0
X = (Max.
width *1 – Width) for (X + Width) > Max. width *1
Y DX1000: 24(0) to 238
DX2000: 40(0) to 478
( ) = Status area set to No
display
This is the Y-coordinate of the right side of the component.
When Y < min. Y
*2 , Y = min. Y *2
When (Y + size) > (min. Y *2 + max. height *3 ), Y = (min. Y *2 + max.
height *3 - size
*1 DX1000 max. width = 320, DX2000 max. width = 640
*2 DX1000 min. Y = 24(0), DX2000 min. Y = 40(0), ( ) = Status area set to No display
*3 DX1000 max. height = 216(240), DX2000 max. height = 440(80), ( ) = Status area set to No display