Yokogawa Button Operated DX2000 - Manual (Page 106)

3-45
IM 04L41B01-62EN
1
2
3
4
5
Index
Detailed Information for
Attributes of Screens and Components
3.22 Attributes of Communication Input
Components
The displayed width of the component frame is 1 dot for the DX1000 and 2 dots for the
DX2000.
The following limitations exist for attribute setting for communication input components.
• [Visible] can only be set when [Depend ID] is set to [None].
• Switching the max. value and the min. value is not possible.
• If a value smaller than [Minimum] is input for [Maximum], [Minimum] becomes that
value.
• If a value larger than [Maximum] is input for [Minimum], [Maximum] becomes that
value.
List of Settings
Refer to Section 3.3 for attributes without explanations in the list of settings.
Attribute Set value/choice
(Underlined items are initial
set values)
Description, conditions
X DX1000: 0 to 318
DX2000: 0 to 638 This is the X-coordinate of the left side of the component.
X = 0 for X < 0
X = (Max.
width *1 – Width) for (X + Width) > Max. width *1
Y DX1000: 24(0) to 238
DX2000: 40(0) to 478
( ) = Status area set to No
display
This is the Y-coordinate of the upper side of the component.
Y = Min. Y
*2 for Y < Min. Y *2
Y = (Min. Y *2 + Max. height *3 – Height) for (Y + Height) > (Min. Y *2 +
Max. height *3 )
*1 DX1000 max. width = 320, DX2000 max. width = 640
*2 DX1000 min. Y = 24(0), DX2000 min. Y = 40(0), ( ) = Status area set to No display
*3 DX1000 max. height = 216(240), DX2000 max. height = 440(80), ( ) = Status area set to No display