Yokogawa Button Operated DX2000 - Manual (Page 125)

3-64
IM 04L41B01-62EN
3.30 Attributes of Line Components
The following limitations exist for setting of attributes of line component attributes.
• [Visible] can only be set when [Depend ID] is set to [None].
List of Settings
Refer to Section 3.3 for attributes without explanations in the list of settings.
Attribute Set value/choice
(Underlined items are initial
set values)
Description, conditions
From X DX1000: 0 to 319
DX2000: 0 to 639 This is the X-coordinate of the start point for component creation.
From X = 0 for From X < 0
From X = (Max. width
*1 – 1) for From X > (Max. width *1 – 1)
From Y DX1000: 24(0) to 239
DX2000: 40(0) to 479
( ) = Status area set to No
display
This is the Y-coordinate of the start point for component creation.
From Y = Min. Y
*2 for From Y < Min. Y *2
From Y = (Min. Y*2 + Max. height *3 – 1) for From Y > (Min. Y *2 + Max.
height *3 – 1)
To X DX1000: 0 to 319
DX2000: 0 to 639 This is the X-coordinate of the end point for component creation.
To X = 0 for To X < 0
To X = (Max. width
*1 – 1) for To X > (Max. width *1 – 1)
To Y DX1000: 24(0) to 239
DX2000: 40 (0)to 479
( ) = Status area set to No
display
This is the Y-coordinate of the end point for component creation.
To Y = Min. Y
*2 for To Y < Min. Y *2
To Y = (Min. Y *2 + Max. height *3 – 1) for To Y > (Min. Y *2 + Max.
height *3 – 1)
*1 DX1000 max. width = 320, DX2000 max. width = 640
*2 DX1000 min. Y = 24(0), DX2000 min. Y = 40(0), ( ) = Status area set to No display
*3 DX1000 max. height = 216(240), DX2000 max. height = 440(80), ( ) = Status area set to No display