Yokogawa EJX930A User Manual
Page 55
<4. Preparation>
4-26
IM 01C25R51-01E
Step 2 Select Default Scan Segment
Specify whether to automatically scan HART devices/Foundation Fieldbus H1 devices after
startup. Select [HART] or [F
OUNDATION
fieldbus] and click [OK].
Figure 4.31b Select HART/F
OUNDATION
fieldbus
NOTE
The software for the communication device starts automatically when [F
OUNDATION
fieldbus] is
selected at [FieldMate]. Refer to Appendix D-3 for how to start the software.
Step 3 FieldMate Segment Viewer window
Open Segment Viewer on FieldMate.
A device icon appears on the window if it is successful to connect to FieldMate. If not, “No device
found” message is shown on the window.
If a connected device icon does not appear, check that initial setting for communication is
correctly done. Refer to section 4.4 for HART and 4.5 for F
OUNDATION
fieldbus.
Figure 4.31c Segment Viewer