Yokogawa EJX930A - Manual (Page 128)

<8. Operation of DYFMVTool> 8-12
IM 01C25R51-01E
(2) Liquid
Figure 8.11 Fluid Operating Range Setup screen (3)
Input operating range and select units
Temperature unit is selectable from degC, degF or Kelvin.
Input Base Condition and select units
Temperature unit is selectable from degC, degF or Kelvin.
NOTE
• Please confirm the density value on the following page (fluid physical property setup page)
and continue configuration.
• If the temperature range input on the “Fluid Operating Range Setup” is too wide, there is a
probability of the calculation error of density is big.
• This range are used only for the density and viscosity calculation.
• Range of Flowmeter are not changed.