IAI America RCS2W - Manual (Page 47)

1. Specifications Check
39
1.3 Option
1.3.1 Brake Type (Model: B)
The brake is a mechanism designed to prevent the rod from dropping on a vertically installed actuator when the
power or servo is turned OFF.
Use the brake to prevent the installed load, etc., from being damaged due to the falling rod.
1.3.2 Reversed–home Specification (Model: NM)
The standard home position is on the motor side. This is the type to indicate when the operation direction is
required to be in the same as the coordinate system of the device that the actuator is mounted on.
1.3.3 Foot Bracket (Model: FT)
It is a metal part to be attached on the bottom of the actuator to affix with screws from top side.
Caution: The home position is adjusted at the factory before shipment. If you wish to change
the home after the delivery of your actuator, you must return the actuator to IAI for
adjustment. Contact our sales office or an agent near you.
55
55
12
84.5
68 80
φ 7
20
RCS2-RA5C/RA5R/RGS5C/RGD5C
Model code of single product: RCS2-FT-RA5
RCS2-SRA7BD
Model code of single product: RCS2-FT-SRA7
88 100
16.5
20
2×2-φ7
15
107 75
75
RCS2-RA4R/ RGS4R/RGD4R
Model code of single product: RCA-FT-RA4R
50
100
150
200
250
300
133
183
233
283
333
383
206
256
306
356
406
456
L1 st L2
ME
SE
st
22
9.5
26
L1
3 3
82.5
115.5
20 20
33
56
10
9
L2 10 10
39
75
40
113.2
60
50.5
20 20
50
100
150
200
250
300
125
175
225
275
325
375
198
248
298
348
398
448
L1 st L2
[RA4R]
2-φ6.8
Home
ME Nut A
φ
37
2-φ6.8
[RGS4R/RGD4R]