Adjust min/max beltstati on volume levels, Confi gure stage announce and sa relay – Clear-Com Tempest2400 User Manual
Page 77
71
Tempest®24 00 2 -Channel Wireless Intercom System
Adjust Min/Max BeltStati on Volume Levels
From the BeltStati on:
•
To set the Minimum volume, press MENU, select “Set Controls,” then “Volume Limit” and “Min Volume.” Use
the Volume knob to adjust the level and press ENTER to save the new setti ng.
•
To set the Maximum volume, advance to “Volume Limit” as above, and then “Max Volume.” Use the Volume
knob to adjust the level and press ENTER to save the new setti ng.
From the BaseStati on:
•
Select the number key 1 through 5 that corresponds to the BeltStati on desired and select “Volume Limit.”
•
To set the Minimum volume setti ng, select “Min Volume.” Use the Volume/Scroll knob to adjust the level and
press ENTER to save.
•
To set the Maximum volume setti ng, select “Max Volume.” Use the Volume/Scroll knob to adjust the level and
press ENTER to save.
Confi gure Stage Announce and SA Relay
From the BeltStati on:
•
To set Stage Announce, press MENU; select “Set Controls;” select “Stage Announce;” select “Momentary.” This is
the default setti ng.
•
To set SA Relay, press MENU; select “Set Controls;” select “Stage Announce;” Select “SA Relay Enable.” This is the
default setti ng.
From the BaseStati on:
•
To set Stage Announce, select the numbered key 1 through 5 that corresponds to the BeltStati on desired.
•
Select “Stage Announce,” select “S/A Audio,” select
Momentary
.
•
Press MENU to go up one level in the menu.
•
Select “Stage Announce” to set “SA Relay” and select
SA Relay Enable
.
•
The STAGE butt on is always
Momentary
when enabled.