Maintenance and care, Cleaning, Temperature and humidity – Clear-Com Tempest2400 User Manual
Page 10
4
Tempest®24 00 2 -Channel Wireless Intercom System
Maintenance and Care
Cleaning
Generally, the Tempest Wireless hardware should be cleaned only with a dry cloth. A soft cloth with rubbing alcohol may
be used to wipe the units if needed. Never spray solvents or chemicals onto the units.
Because of Tempest’s weather resistant design, it is not highly suscepti ble to dust or airborne contaminants. However, all
electronic devices can be suscepti ble to parti culate contaminati on. If exposed to an extremely dusty environment, contact
an authorized Tempest service center for internal cleaning.
Temperature and Humidity
Ideally, all electronics should be stored and used in a controlled environment with moderate temperature and humidity.
Tempest components are designed to be very durable, and can tolerate a wide range of environmental conditi ons.
Install the BaseStati on in a locati on where it will not be exposed to extreme weather conditi ons. Protect the unit against
dust or moisture. Always protect any AC power connecti ons from the elements with safety in mind.
For more extreme environmental conditi ons, the BaseStati on can remain in a secure locati on with antennas for the
BaseStati on located remotely and connected by low-loss 50 ohm coax cable, or the opti onal Remote Transceiver can be
used.
The Tempest Remote Transceiver is weather resistant, with gaskets intended to prevent moisture entry from the top and
sides. The CAT-5 cable connecti on on the bott om is not water ti ght. If it is to be used in an environment subject to blowing
rain, snow, fog or high humidity, protect the transceiver with a cover that will not interfere with the RF.
The BeltStati ons are designed to work wherever people work. While the BeltStati on design is weather resistant, the headset
XLR connector on the bott om is not waterti ght. BeltStati ons should not be submerged in liquids. Protect the batt ery
compartment from water when changing batt eries. The batt ery compartment off ers a route to the electronic circuitry.