Clear-Com Tempest2400 - Manual (Page 20)

14 Tempest®24 00 2 -Channel Wireless Intercom System
Front Panel Right
1- 2-Wire Intercom Type Slide Switch A&B
The 2-Wire Intercom Type slide switch confi gure the BaseStati on for the type of intercom that will be connected to the
corresponding 2-Wire connectors on the rear panel of the BaseStati on. Clear-Com, RTS, or BAL (AudioCom) can be selected.
This switch only aff ects 2-Wire operati on and not 4-Wire operati on. The A&B switch selects the 2-Wire system type for both
the A and the B intercom channels.
2- Wired Intercom Channel Select (SEL) Butt on
The Intercom Channel Select (SEL) butt on is used to select one of the two intercom channels so that the intercom mode
-- 2-Wire or 4-Wire -- and audio input and output levels, may be adjusted.
Pressing the CHAN SEL butt on puts the BaseStati on into Menu Mode and advances to the Intercom Levels screen.
Pressing the CHAN SEL butt on a second ti me selects channel A, for the opportunity to select 2-Wire or 4-Wire or no wired
connecti on, and IN and OUT levels can be adjusted (see 2-Wire/4-Wire Select below.)
Additi onal presses advance through the intercom channels, and return to Operati onal Mode. The intercom channel selected
is indicated by the two “CHAN” LEDs located to the immediate right of the SEL butt on.
Also, in the Aux IN/OUT menu, SEL advances through the channels to adjust the Aux IN and Aux OUT levels.
3- Channel (CHAN) LEDs
In Operati onal Mode, the two Channel (CHAN) LEDs labeled A and B are always illuminated.
Enter Menu Mode, by pressing the Channel Select (SEL) butt on ([2] above). In Menu Mode, the Channel LEDs indicate the
channel currently selected for adjustment. Only one channel may be selected at a ti me.
The Front Panel Right controls 1 – 7, will normally be used together to confi gure the Tempest
BaseStati on for 2-Wire or 4-Wire operati on.
Select the appropriate 2-Wire switch setti ng prior to connecti ng the 2-Wire intercom. Do not
switch between 2-Wire types while connected to a 2-Wire system and powered ON. The
diff erent voltages in each system may damage equipment.