Clear-Com Tempest2400 - Manual (Page 12)

6 Tempest®24 00 2 -Channel Wireless Intercom System
Quick Start Guide
What You Will Need
BaseStati on
» Power cord
» One BaseStati on antenna
» 3.5mm male-to-male mini-stereo
pairing cable
BeltStati ons
» Up to 5 per BaseStati on
» Lithium-Polymer batt ery and
» Charger - 1 per BeltStati on
Headsets (customer supplied)
» 1 per BeltStati on
» 1 per BaseStati on
1. Connect a whip antenna onto the back of the BaseStati on.
Select a suitable locati on for the BaseStati on. Tempest is a radio system, broadcasti ng and receiving RF signals that are
aff ected by physical and electronic barriers.
The antenna should be located as high as possible and away from all
obstructi ons. When using a whip (omni-directi onal) antenna , select a
locati on as close as possible to the center of the area you want to cover.
Use alternati ve antenna opti ons when the BaseStati on is in a rack or other
metal structure, or stacked with other gear. Remote locati on antenna
placement of up to 1,500 ft . can be achieved using the Tempest Remote
Transceiver. See the user manual for more details about antenna placement,
recommended cable types, and other antenna opti ons.
2. Connect the power cord and Power On the BaseStati on.
3. Install Batt eries in BeltStati ons
Install the Lithium-Polymer batt ery in each BeltStati on. Be certain that the gold
contacts on the batt ery touch the contacts in the batt ery compartment. The batt ery
is shipped with a parti al charge, so charging will be necessary before maximum run
ti me will be achieved.
OR
Insert (3) AA alkaline batt eries in the batt ery compartment. Always replace the
batt ery cover.
To power ON the BeltStati on, press and hold the power butt on for approximately
two seconds. The display will indicate “None Selected.” Turn the power OFF by
holding the power butt on for four seconds.