Clear-Com Tempest2400 - Manual (Page 13)

7 Tempest®24 00 2 -Channel Wireless Intercom System
4. Pair BeltStati ons to the BaseStati on
Pairing is a programming process that allows a BaseStati on and BeltStati on to
recognize each other.
» Confi rm that the BaseStati on is powered ON.
» Confi rm that the BeltStati on is powered OFF.
» Connect the Pairing Cable from the BaseStati on to a BeltStati on.
» Power ON the BeltStati on and watch the BeltStati on display for “Pairing
Complete.”
» BeltStati on status will become visible on the BaseStati on display.
» Repeat with each BeltStati on.
5. Connect Headsets to BeltStati ons
Plug a headset into each BeltStati on, and the BaseStati on if desired.
6. Operati on
Select a channel on the BeltStati ons by pressing the CH A or CH B control.
Press the TALK butt on. A quick press latches the Talk butt on for “Hands Free”
operati on. Press and hold the Talk butt on for more than two seconds while you
talk and the butt on will release in a Push-To-Talk manner.
Set the volume by rotati ng the CH A or CH B control.
You may confi rm BeltStati on operati on on the BaseStati on Operati on
screen. There is a secti on for each BeltStati on. In this illustrati on, each
BeltStati on is set to talk on channel A and listen on channels A & D, with
only three BeltStati ons in operati on.
A headset may be connected to the front of the Base Stati on. Acti vate by pressing the TALK butt on. Select a channel by
pressing the volume knob.
Refer to the user manual for detailed instructi ons regarding:
» Country limitati on on 2.4G Hz RF spectrum.
» Adjusti ng the Network Number and Lockout Key.
» Assigning names for equipment.
» Charging batt eries.