Clear-Com Tempest2400 - Manual (Page 48)

42 Tempest®24 00 2 -Channel Wireless Intercom System
BeltStati on Setup
Steps to Setup the BeltStati ons
• Install the batt ery.
• “Pair” BeltStati ons to the BaseStati on.
• Adjust slot setti ngs as needed.
• Connect a headset.
• Adjust Mic Gain.
• Adjust Sidetone.
• Confi gure opti onal features:
» Name the BeltStati on.
» Disable unused functi ons, channels, and butt ons.
» Select/disable relay opti ons as needed.
» Adjust personal preferences.
Batt ery Selecti on and Installati on
The Tempest BeltStati on Batt ery Compartment holds either one Tempest Lithium-Polymer rechargeable batt ery or three
standard alkaline AA cells. Lithium-Polymer batt eries are the primary power source. High quality alkaline AA cells may be
used in situati ons where Lithium-Polymer batt eries are not available or are not charged. One Lithium-Polymer batt ery
comes standard with each Tempest BeltStati on. Additi onal Lithium-Polymer batt eries may be purchased. Contact your
dealer or distributor to purchase additi onal batt eries. The Lithium-Polymer batt eries supplied with your Tempest Wireless
system are warranted for 90 days from the date of purchase.
Lithium-Polymer batt eries off er up to nine hours of batt ery life and recharge in
approximately 2¾ hours.
Lithium-Polymer batt eries ship from the factory with approximately 50% charge. It
will not damage the Lithium-Polymer batt eries to use them without charging them
fi rst. This will, however result in shorter run ti me unti l the Lithium-Polymer batt ery
is fully charged. When possible, charge Lithium-Polymer batt eries to full capacity to
ensure full batt ery life prior to use.
Using (3) alkaline AA batt eries can provide up to four hours of batt ery life. Use
only high quality alkaline AA cells. This will provide enough ti me to fully charge the
Lithium-Polymer batt ery.
To remove the batt ery door, press down on the thumb markings and pull the batt ery door toward the bott om of the
BeltStati on.
To remove batt eries from the batt ery compartment, turn the BeltStati on batt ery side down and tap the bott om of the
BeltStati on on the palm of your other hand.
Please be careful to insert alkaline AA batt eries according to the marked polarity. All of the alkaline AA cells must be
oriented the same directi on.
If the batt ery cover does not close properly, the batt ery may not be inserted correctly.