Clear-Com Tempest2400 - Manual (Page 23)

17 Tempest®24 00 2 -Channel Wireless Intercom System
Rear Panel Right
1- SA (Stage Announce) Connector
The SA connector is used to output BeltStati on audio to a dedicated audio output. The SA Connector is an XLR-3M connector
and accepts a standard XLR-3F. The SA Connector is balanced and transformer isolated. Nominal line level is -12 to +8 dBu.
The SA Connector output level can be adjusted under the Wired Intercom Setti ngs menu.
2- Aux IN Connector
The Auxiliary IN Connector is used to supply program or other audio sources to the Tempest BaseStati on. The Auxiliary IN
Connector is a ¼” Tip/Ring/Sleeve jack that accepts a standard ¼” TRS plug. The Auxiliary IN Connector is balanced and
transformer isolated. Nominal line level is -15.5 to +4 dBu. Audio supplied to the Aux IN Connector can be assigned to any
combinati on of the four intercom channels with individual levels for each channel at the “Aux In/Out Assignment/Level”
menu. While in the Aux In/Out Assignment/Level menu, the front panel CHAN SEL butt on or the Volume control can be
used to advance through the channels, and the IN Level control is used to adjust the Aux IN level. Adjust to the lowest level
to restrict audio from a channel.
3- Aux OUT Connector
The Auxiliary OUT Connector is used to supply intercom audio sources from the Tempest BaseStati on. The Auxiliary OUT
Connector is a ¼” Tip/Ring/Sleeve jack that accepts a standard ¼” TRS plug. The Auxiliary OUT Connector is balanced and
transformer isolated. Nominal line level is -12 to +8 dBu. Audio supplied from the Auxiliary OUT Connector can be assigned
from any combinati on of the four intercom channels with level control at the “Aux In/Out Assignment/Levels” menu. While
in the Aux In/Out Assignment/Level menu, the front panel CHAN SEL butt on or the Volume control, can be used to advance
through the channels, and the OUT Level control is used to adjust the Aux Out level. Adjust to the lowest level to restrict
audio from a channel.
4- Base Sync IN Connector
The Accu-Sync, BaseSync IN Connector is used to input an external sync signal that ensures that multi ple Tempest
BaseStati ons all transmit and receive at the same ti me, thus avoiding inter-BaseStati on RF interference.
5- Base Sync OUT Connector
The Accu-Sync, BaseSync OUT Connector is used to output a sync signal that ensures that multi ple Tempest BaseStati ons all
transmit and receive at the same ti me, thus avoiding inter-BaseStati on RF interference. Any BaseStati on that has a BaseSync
OUT connecti on, but does not have a BaseSync IN connecti on, will generate a sync signal for connected BaseStati ons.