Clear-Com V12PDDXY - Manual (Page 149)

If the AES-3 option/AES-6 interface is used to connect the V-Series panel using a 3rd-party
AES-3 network the system setup is as shown below.
Figure 177: Panel connected by 3
rd
party AES-3 network
Note:
The cable specifications are as stated previously unless the connections to the 3rd party
network require different cable specifications. In this case the customer should contact
Clear-Com for advice.
7.2.16 T-Adapter option to DIG-2/DIF-102 interface
The T-Adapter option module adds 2-wire digital input and output via RJ-45 to V-Series main
panels. If the T-Adapter digital interface option is used to connect the V-Series main panel
to the matrix it must be connected via a DIG-2 Digital Interface instead of directly to an MVX-
16 analog port on the matrix.
Tip: For information on the DIG-2/DIF-102 digital interface, see the DIG-2 manual and the
Interface Module Frames manual.
Figure 178: Panel with T-Adapter interface
149 V-Series Panels User Guide