15 aes-3 option to aes-6 interface card, Aes-3 option to aes-6 interface card – Clear-Com V12PDDXY User Manual
Page 147
Note:
When wiring headset 2 to use the auxiliary audio connector, Clear-Com recommends using
good quality headphone cable to avoid pickup of electronic noise by the microphone
connection.
Wire the Headset 2 PTTs (pins 4 and 17) so that PTT connects the pin to ground.
The auxiliary loudspeaker output is at line levels, and auxiliary loudspeakers cannot be
connected directly. Auxiliary loudspeakers must be driven through a suitable audio amplifier.
The line output levels are given in the product specifications.
7.2.15
AES-3 option to AES-6 interface card
The AES-3 option module adds digital input and output using RJ-45 or coax to V-Series
main panels.
If the AES-3 digital interface option is used to connect the V-Series main panel to the matrix
it must be connected to an AES-6 Digital Interface instead of the MVX-16 serial ports on the
matrix.
Tip:
For more information about the AES-6 digital interface, see the AES-6 manual.
Figure 176: V-Series panel with AES-3 connection
147
V-Series Panels User Guide