Clear-Com V12PDDXY - Manual (Page 111)

6 IP Configuration
IP-enabled V-Series panels can connect to an Eclipse or Eclipse HX matrix over a standard
Ethernet network using an IVC-32 card. Each IVC-32 card can support up to 32
V-Series panels using IP.
The IP settings for the panel are configured using the IP configuration menus, described in
this chapter.
Important note:
V-Series panels running application code V1.73 or above are automatically IP-enabled. V-
Series panels running earlier versions of the application code must be enabled for IP
operation by either:
• Inputting a ten digit passcode to the panel.
• Upgrading to V1.73 or above of the application code.
6.1 Accessing the IP configuration menus
To access the IP menus, select Menu and then Info. The panel displays the Local
Maintenance Menu (LLM). Select IP SETUP to enter the IP configuration menus.
Tip: If you enter PANEL INFO instead, you enter the maintenance menus.
See 8 Maintaining V-Series panels .
To communicate to ECS / EHX that the panel is ready to be identified, select IDENTIFYME.
The panel buttons or LEDs flash red and IDENTIFYME is displayed in the bottom left
display screen. Select IDENTIFYME again (the Reply key) to cancel identify mode.
Identification mode can also be initiated in ECS /EHX, in which case the same display mode
is seen.
Note:
If the LAN port is the only connection with the panel, the panel will automatically display the
IP SETUP menu, prompting the user to enable the panel for IP access (if it is not already
enabled (see above)).
111 V-Series Panels User Guide