Clear-Com V12PDDXY - Manual (Page 102)

2. Press the appropriate key or talk button for the required IFB destination. The status
LED, pushbutton or talk button for the selected key is now lit solid red .
Note:
Pressing the key or talk button again deactivates the assignment
Valid IFB sources are indicated by the status LEDs, pushbuttons or talk buttons
flashing green.
3. Press the appropriate key or talk button for the required IFB source. The status LED,
pushbutton or talk button for the selected key is now lit solid green.
Note:
Pressing the key or talk button again deactivates the assignment.
4. Repeat steps 3 and 4 until all IFB sources are assigned to the IFB destination.
Rotary panel IFB setup: setting the audio levels
On rotary panels, you can set the audio levels when assigning IFB sources and
destinations using the rotary controls.
To change the audio levels:
1. Select the IFB destination (see above procedure).
2. Turn the rotary control associated with the selected IFB destination key. The display
changes to show the audio level and the type of level being adjusted. When the talk
button is pressed the output level to the IFB destination is set.
3. Select the IFB source(s) (see above procedure).
4. Turn the rotary control associated with the selected IFB source key. The display
changes to show the audio level and the type of level being adjusted. When the talk
button or rotary control is pressed the input level to the matrix is set.
Figure 118: Rotary panel IFB audio level setup
102 V-Series Panels User Guide