Clear-Com V12PDDXY - Manual (Page 121)

The NET SETUP menu options are used to configure IP addresses and network connection
parameters:
Menu option Description / comments
IP ADDRESS Used to set the IP address of the panel.
IP GATEWAY Used to set the IP address of the gateway that the panel uses when
connecting to the matrix.
DNS SERVER Used to set the IP address of the Domain Name server used by the
panel.
MATRIX IP Used to set the IP address of the matrix the panel will connect to. The
address refers to the IVC-32 card address that is set up in ECS / EHX.
LOGIN PORT Used to set up the IP port that the panel uses when logging in to the
matrix.
The login port must be the same as the port set up in ECS / EHX under
System Preferences > IP Panels. When the panel logs in, the panel
will be sent the IP address and port to use when communicating with
the IVC-32 card. This is configured in ECS / EHX under Matrix
Hardware.
DHCP Used to enable or disable DHCP (Dynamic Host Configuration
Protocol).
If enabled, the panel can be assigned an IP address, subnet mask,
gateway address and DNS server automatically from the DHCP server
rather than having to manually configure the panel.
When DHCP is enabled, pushbutton panels will show the DHCP
pushbutton
flashing green . Lever key panels will show the talk/listen
indicator flashing green . IVC-32 cards should be assigned
automatically to ensure manually assigned addresses do not clash with
those assigned by the DHCP server.
SUBNETMASK Used to set the subnet mask for the IP network the panel is to be used
on. Commonly the subnet mask will be 255.255.255.0.
CON TYPE Used to determine the connection type (WAN (Wide Area Network),
LAN (Local Area Network) or INTERNET).
The connection type may determine whether DHCP and DNS are used.
Table 30: NET SETUP menu options
121 V-Series Panels User Guide