Burkert Type 8635 - Manual (Page 95)

8635 - 93
O
PERATING THE
P
ROCESS
C
ONTROLLER
(S/HART)
Xd2 Xd2
Xd2'
Xd2'
to controller
Process
value
(PV)
Process setpoint
(SP) Control
difference
Dead band
Entering the dead band in %
Insensitivity range with process control
P.CO - DBND
Insensitivity range (dead band) of the process controller
Factory setting: 1% (relative to the range width of the process value scaled by SCAL PV und PV )
This function assures that the process controller cuts in only above a certain control difference. The
function reduces wear on the piezoelectric valves in the SIDE Control
(S/HART) and the pneumatic
actuator.
P.CO DBND DBND XX.X