Burkert Type 8635 - Manual (Page 64)

62 - 8635
O
PERATING AND
C
ONTROLLER
F
UNCTIONS
ADDFUNCT
CUTOFF
DIR.CMD
CHARACT
DIR.ACT
SPLTRNG
X.LIMIT
X.TIME
X.CONTRL
P.CONTRL
CODE
BIN-IN
OUTPUT
CAL USER
ENDFUNCT
SETFACT
SIG-ERR
SAFEPOS
S/H
S/H
S/H
S/H
S/H
S/H
S/H
Supplementary functions
The supplementary functions marked with S/H are available only in the S/HART version
of the SIDE Control.
NOTE
Select the transfer characteristic between input
signal and stroke (correction characteristic)
Tight-closing function for positioner or for
active process controller (S/HART only)
Sense of action between input signal and setpoint
position
Allocation of state of pressurization of actuator
chamber (Port 2
1
) to actual position
Splitting of signal range; input signal in % for which
the valve runs through the entire stroke range.
Limitation of mechanical stroke range
Parametrization of positioner
(Parametrization of PID process controller)
In version as positioner: no function!
Code protection for settings
Limitation of correcting speed
Activation of binary input
[Configuration of the outputs (only with supplementary
board for analog repeat or binary outputs)]
Calibration
Reset for factory settings
Enter safe position
Configure error recognition, signal level