beautypg.com

Error messages and malfunctions maintenance, Error messages on the lc display – Burkert Type 8635 User Manual

Page 136

background image

134 - 8635

M

AINTENANCE AND

E

RROR

E

LIMINATION ON THE

P

OSITIONER

Display

Causes of error

Remedy

X.ERR 1

No compressed air connected

Connect compressed air

X.ERR 2

Air pressure failure during

AUTOTUNE

Check compressed air supply

X.ERR 3

Actuator system or actuator

None, device faulty

system leaky on exhaust side

X.ERR 4

Actuator system leaky on pressurized

None, device faulty

side

X.ERR 5

The dead band of the internal

Check alignment of the axle of the SIDE

position sensor system is

Control and correct

exceeded

(see chapter

Installation)

X.ERR 6

The end positions for

POS-MIN and

Check whether the allocation of the

POS-MAX are too near together.

end positions to

POS-MIN and

POS-MAX via the function TUNE-
POS is correct.
If incorrect:
execute

TUNE-POS again.

If correct:
TUNE-POS with this arrangement of the
end positions is not possible since
they are too close together.

X.ERR 7

False allocation of

POS-MIN and

To determine

POS-MIN and POS-MAX,

POS-MAX

move the actuator in each case in the
direction shown on the display.

Error messages on the LC display

When operated according to these Operating Instructions

, the SIDE Control is maintenance free.

Error messages and malfunctions

Maintenance

General error messages

Display

Causes of error

Remedy

INT.ERROR

Internal error

None, device faulty

Error messages on execution of the function X.TUNE