Burkert Type 8635 User Manual
Page 44
42 - 8635
I
NSTALLATION
Attachment to a continuous valve with part-turn actuator
The axle of the position sensor built into the SIDE Control is coupled directly to the axle of the part-turn
actuator.
Add-on kit to part-turn activator (Id no. 651 741)
Other accessories required
Attachment bracket with fixing screws (acc. to VDI/VDE 3845) - available from the manufacturer of the
part-turn actuator.
Assembly
Determine the orientation of attachment of the
SIDE Control (parallel to the actuator or rotated
by 90°).
Determine the basic position and direction of
rotation of the actuator.
Push adapter (1) onto the axle of the SIDE
Control and fix it with 2 setscrews (2). One of
the setscrews should press onto the flat on the
axle (
to prevent slip!). It must be assured that
the axle of the SIDE Control can move only in
one of the ranges shown below in the drawings
observe the flat on the axle!.
(obtainable from Bürkert as an
accessory)
Serial
no.
Quan-
tity
Designation
1
1
Adapter
2
2
Setscrew DIN 913 M4 x 4
3
4
Cap screw DIN 933 M6 x 12
4
4
Lock washer B6
Swing angle 90°
Flat on shaft!
Swing angle 90°
Flat on shaft!