Burkert Type 8635 User Manual

Page 43

8635 - 41

NSTALLATION

Actuator with cast frame

Fix the SIDE Control with bracket by means of one or more hex screws (8), washers (11) and lock
washers (10) to the cast frame.

Alignment of the lever mechanism

The lever mechanism can only be aligned properly when the device has been connected electrically

and pneumatically.

In the manual mode, move the actuator to half stroke (corresponding to scale on actuator).

Move the device vertically until the lever is horizontal.

Fix the device finally to the actuator.

Actuator with post yoke

Fix the SIDE Control with bracket with U-bolts (7),

washers (11), lock washers (10) and hex nuts (21) to the post yoke.