Burkert Type 8635 User Manual

Page 42

40 - 8635

NSTALLATION

Assembly

Mount U-piece (2) using clamping pieces (3), hex screws (17) and lock washers (16) on actuator
spindle.

Select the short lever (Table

Add-on kit to linear actuator, Serial no. 6a) or long lever (Table Add-on kit

to linear actuator, Serial no. 6b), depending on the actuator stroke.

Assemble the lever (if not preassembled).

The distance of the driving pin from the axle should be
equal to the actuator stroke. This results in a swing angle of
the lever of 60°. This assures that the position sensor works
with good resolution. The scale printed on the lever is irrele-
vant.

Push the lever onto the axle of the SIDE Control and screw it tight.

Fix attachment bracket (1) with hex screws (9), lock washers (10) and washers (11) to the rear side
of the SIDE Control.

Which M8 thread on the SIDE Control is

chosen depends on the size of the actuator

To determine the correct position, hold the
SIDE Control with bracket against the
actuator. The conical roller (5) on the lever
of the position sensor must be able to move
freely in U-piece (2) on the actuator over
the entire stroke. At 50% stroke, the lever
position should be roughly horizontal (see
under

Alignment of the lever mechanism).

NOTE

Swing angle of

er (60°)

Separation = stroke of actuator