Burkert Type 8635 - Manual (Page 13)

8635 - 11
G
ENERAL
N
OTES
ATTENTION
EXERCISE CAUTION ON HANDLING!
ELECTROSTATICALLY SENSITIVE
COMPONENTS / MODULES
This device contains electronic components that are sensitive to
electrostatic discharge (ESD). Contact to electrostatically charged persons
or objects will endanger these components. In the worst case, they will be
immediately destroyed or will fail after commissioning.
Observe the requirements of EN 100015-1 (IEC 61340-5-1) in order to
minimize the possibility of, or avoid, damage from instantaneous
electrostatic discharge. Also take care not to touch components that are
under supply voltage.
Protection from damage by electrostatic charging
Device-related notes
• For installation and operation in potentially hazardous (explosive) locations, observe the regulations.
These are to be found in EN 60079-14 (IEC 60079-14).
• On electrical connection of the inherently safe circuits, observe the data in the relevant certificate of
conformity.
• Take suitable precautions to prevent electrostatic charging of plastic parts of the housing
(see EN 100015-1 / IEC 61340-5-1).
• No components shall be connected to the inputs and outputs of the boards whose electrical data lie
outside the limits determined for inherently safe operation and stated on the data sheet for the
positioner.
• In potentially explosive locations, only inherently safe devices (of EN 50020 / IEC 60079-11) shall
be connected to the serial interface.
• The plastic covering shall be removed only by the manufacturer!
• Interventions in the device with the housing open shall not be carried out in very humid or aggressive
atmospheres. Take precautions to prevent inadvertent mechanical damage to the boards or their
components. Limit the duration of opening of the housing to that which is absolutely necessary.
Scope of delivery
Immediately after receipt of a shipment, make sure that the contents are undamaged and match the
scope of delivery stated on the packing slip. In general this consists of:
• SIDE Control
• Operating Instructions for the SIDE Control
Add-on kits for linear and part-turn actuators may be obtained as accessories.
If there are discrepancies, please contact immediately our customer service:
Bürkert Fluid Control Systems / Service Department
Chr.-Bürkert-Str. 13-17
D-76453 Ingelfingen
Tel.: (+49 7940) 10-111 Fax: (+49 7940) 10-448
E-Mail: [email protected]
Bürkert Fluid Control System
Sales Center
Christian-Bürkert-Str. 13-17
D-74653 Ingelfingen
Tel. + 49 (0) 7940 - 10 91 111
Fax + 49 (0) 7940 - 10 91 448
E-mail: [email protected]