Burkert Type 8635 - Manual (Page 81)

8635 - 79
O
PERATING AND
C
ONTROLLER
F
UNCTIONS
➀ ➀ ➀ ➀ ➀
BIN1 DEV.X
Selection: alarm output for too great an actuating signal from the positioner
* The permissible actuating signal DEV.X XXX shall not be smaller than dead band.
➁ ➁ ➁ ➁ ➁ BIN1 LIM.X
Selection: binary position output
LIM.X XXX - limit position
➂ ➂ ➂ ➂ ➂ BIN1 SPOS
Selection: actuator in safety position
➃ ➃ ➃ ➃ ➃ BIN1 SIG.P
Selection: error message in process value signal
➄ ➄ ➄ ➄ ➄
BIN1 RMOT
Selection: operating mode Automatic and External Setpoint activated
NOTE NORM CLS (NC) "Normally Closed"-
output, in switched state
low (<1.2 mA)
NORM OPN (NO) "Normally Open"-
output, in switched state
high (>2.1 mA)
OUT BIN1 NORM OPN NORM CLS
POS > LIM <1.2 mA >2.1 mA
POS < LIM >2.1 mA <1.2 mA