Avaya P130 - Manual (Page 95)

Chapter 6 Avaya P130 CLI
Avaya P130 User’s Guide 81
FlowControl Commands
Set internal buffering Command
Use the set internal buffering command to set the size (either Maximum
or Minimum) of the Receive (Rx) buffer allocated to each port of the specified
module. This command is meaningless when any port of the module is operating
with flow control ON. You must reset the switch after setting the internal buffering
parameters.
The syntax for this command is:
set internal buffering {max|min}
Example:
P130-N> set internal buffering 1 max
Done.
Show internal buffering Command
Use the show internal buffering command to show the size options
(Maximum, Minimum, or Medium) of the Receive (Rx) buffer allocated to each port
of the specified module.
The syntax for this command is:
show internal buffering []
Example:
P130-N> show internal buffering 1
Module Internal Buffer
------ ---------------
1 med
Set port flowcontrol Command
See Set port flowcontrol Command on page 74
Show port flowcontrol Command
See Show port flowcontrol Command on page 67.
max Sets the internal receive buffer to its maximum size.
min Sets the internal receive buffer to its minimum size (this is the
Default).
Module number