Avaya P130 - Manual (Page 88)

Chapter 6 Avaya P130 CLI
74 Avaya P130 User’s Guide
Example:
To set port 2 on module 1 to full duplex:
P130-1# set port duplex 1/2 full
Port 1/2 set to full-duplex.
P130-1#
Set port flowcontrol Command
Use the s et port flowcontrol command to set the send/receive flow-control
frames (whether proprietary or IEEE 802.3x) for a full duplex module port. Each
direction can be configured separately.
This command is supported on Fast and Gigabit Ethernet switching ports.
The syntax for this command is:
set port flowcontrol {receive | send | all}port_num>{off | on | prop}
receive Indicates whether the port can receive administrative status
from a remote device. Available only for Gigabit Ethernet
modules with negotiation set to off.
send Indicate whether the local port can send administrative status
to a remote device. Available only for Gigabit Ethernet
modules with negotiation set to off.
all Send and receive (symmetric flow control).
mod_num Module number
port_num Number of the port on the module
off Used with receive to turn off an attached device's ability to
send flow-control packets to a local port. Used with send to
turn off the local port's ability to send administrative status to a
remote device.
on Used with receive to require that a local port receive
administrative status from a remote device. Used with send,
the local port sends administrative status to a remote device.
prop Proprietary flow control.