Avaya P130 - Manual (Page 63)

Chapter 6 Avaya P130 CLI
Avaya P130 User’s Guide 49
Show interface Command
Use the show interface command to display information on the management
interfaces.
The syntax for this command is:
show interface [{ppp | inband}]
Example:
P130-N> show interface
Interface Name VLAN IP address Netmask
-------------- ---- --------------- ---------------
inband 1 149.49.34.211 255.255.255.0
ppp 1 0.0.0.0 0.0.0.0
Set interface Command
Use the set interface command to configure the in-band interfaces on the
switch.
The syntax for this command is:
set interface [name][vlan][ip_addr][netmask]
Show log Command
Use the show log command to display Log files of all modules or of a specific
module.
The syntax for this command is:
show log [[-]]
name Interface name ("inband" used for Master agent)
vlan The number of the VLAN to be assigned to the interface
ip_addr IP address
netmask Subnet mask
[[-]] One or more module numbers