Avaya P130 - Manual (Page 127)

Chapter 6 Avaya P130 CLI
Avaya P130 User’s Guide 113
SNMP Commands
Show snmp Command
Use the show snmp command to display SNMP information.
The syntax for this command is:
show snmp
Example:
P130-N> show snmp
Authentication trap disabled
Community-Access Community-String
---------------- ----------------
read-only public
read-write public
trap public
Trap-Rec-Address Traps Enabled
---------------- ----------------
1.1.1.1 config
fault
etc...
Show snmp retries Command
Use the show snmp retries command to display the number of retries initiated
by the Device Manager application when it tries to send SNMP messages to the
device.
The syntax for this command is:
show snmp retries
Example:
P130-N> show snmp retries
the SNMP Retries Number is 3