Avaya P130 - Manual (Page 117)

Chapter 6 Avaya P130 CLI
Avaya P130 User’s Guide 103
Set ppp incoming timeout Command
Use the set ppp incoming timeout command to configure the number of
minutes until the system automatically disconnects an idle PPP incoming session.
The syntax for this command is:
set ppp incoming timeout
Example:
P130-1# set ppp incoming timeout 20
PPP incoming sessions will automatically disconnect after 20
minutes of idle time.
Show ppp configuration Command
Use the show ppp configuration command to view the ppp configuration.
The syntax for this command is:
show ppp configuration
Example:
P130-N> show ppp configuration
PPP baud rate is 38400
PPP incoming timeout is 0 minutes
PPP Authentication Parameters:
------------------------------
Incoming: PAP
Number of minutes between 0 to 999 until the system
automatically disconnects an idle PPP session.
Setting the value to 0 disables the automatic
disconnection of idle sessions. The default is no
timeout.