Reset commands, Reset command, Nvram initialize command – Avaya P130 User Manual
Page 79: Reset command nvram initialize command, Age 65
Chapter 6 Avaya P130 CLI
Avaya P130 User’s Guide
65
Reset Commands
Reset Command
Use the
reset command to restart the P130 switch. You must type the command in
full.
The syntax for this command is:
reset {
Example:
P130-1# reset
This command will force a switch-over to the master module and
disconnect your telnet session.
Do you want to continue (y/n) [n]? y
Connection closed by foreign host.
Nvram initialize Command
Use the
nvram initialize command reset the P130 parameters to the factory
defaults. If no options are specified for this command, only the Layer 2 parameters
will be reset.
The syntax for this command is:
nvram initialize {switch | all}
Example:
P130# nvram initialize
This command will force a factory default and switch-over to
the master module and disconnect your telnet session.
Do you want to continue (y/n) [n]? y
Connection closed by foreign host.
host%
Number of the module to be restarted
switch
Resets all the switching level parameters (Layer 2
only)
all
Resets all parameters including Multilayer Policy
parameters