Avaya P130 - Manual (Page 90)

Chapter 6 Avaya P130 CLI
76 Avaya P130 User’s Guide
Set port name Command
Use the set port name command to configure a name for a port. If you do not
specify a name, the port name remains empty.
The syntax for this command is:
set port name / []
Example:
P130-1# set port name 1/21 arthur
Port 1/21 name set.
Set port trap Command
Use the set port trap command to enable/disable generic SNMP uplink /
downlink traps from a port.
The syntax for this command is:
set port trap / {enable | disable}
Example:
P130# set port trap 1/21 enable
Port 1/21 up/down trap enabled.
mod_num Module number
port_num Number of the port on the module
Name assigned to the port.
mod_num Module number
port_num Number of the port on the module
enable Enables generic SNMP uplink/downlink traps from a port
disable Disables generic SNMP uplink/downlink traps from a port