beautypg.com

Show port mirror command, Set port level command, Show port mirror command set port level command – Avaya P130 User Manual

Page 84

background image

Chapter 6 Avaya P130 CLI

70

Avaya P130 User’s Guide

Example:

To display LAG information data for port 10 on module 1:
P130-N> show port channel 1/10 info
Port Speed Duplex Vlan Port Trunk Vlan
Priority status Binding
------ ------ ------- ----- --------- -------- --------
1/10 10 half 1 0 off all
1/11 10 half 1 0 off all

Show port mirror Command

Use the

show port mirror command to display mirroring information for the

switch.

The syntax for this command is:
show port mirror [[/]]

Example:
P130-N> show port mirror
port mirroring
Mirroring both Rx and Tx packets from port 1/2 to port 1/4 is
enabled

Set port level Command

Use the

set port level command to set the priority level of a port or range of

ports on the switching bus. Packets traveling through a port set at normal priority
should be served only after packets traveling through a port set at high priority are
served. Packets traveling with a 802.1p priority header are not affected by this
command.

The syntax for this command is:
set port level / {[0-7]}

mod_num

Module number

port_num

Number of the port on the module

mod_num

Module number

port_num

Number of the port on the module