Avaya P130 - Manual (Page 120)

Chapter 6 Avaya P130 CLI
106 Avaya P130 User’s Guide
Set radius authentication server Command
Use the set radius authentication server command to set a primary or
secondary RADIUS server IP address.
The syntax for this command is:
set radius authentication server
Example:
P130-N(super)# set radius authentication server 149.49.38.12
primary
Clear radius authentication server Command
Use the clear radius authentication server command to remove a
primary or secondary RADIUS authentication server.
The syntax for this command is:
clear radius authentication server[{primary|secondary}]]
Example:
P130-N(super)# clear radius authentication server primary
Set radius authentication retry-time Command
Use the set radius authentication retry-time command to set the time
to wait before re-sending an access request.
The syntax for this command is:
set radius authentication retry time
IP address of the RADIUS authentication server
Default - Primary authentication server
Secondary authentication server
primary Primary authentication server
secondary Secondary authentication server
Retry time in seconds