Set port redundancy command, Show port redundancy command – Avaya P130 User Manual
Page 92
Chapter 6 Avaya P130 CLI
78
Avaya P130 User’s Guide
Set port redundancy Command
Use the
set port redundancy command to define/remove redundancy
schemes between a Primary and a Secondary link. The link can be any port that does
not belong to a LAG, or a LAG interface. In either case, there should not be any
redundancy scheme already defined on any of the links.
The syntax for this command is:
set port redundancy
Example:
P130-1# set port redundancy 1/7 2/12 on red1
uplink: Port 2/12 is redundant to port 1/7.
Port redundancy is active - entry is effective immediately
Show port redundancy Command
Use the
show port redundancy command to display information about all
redundancy schemes defined in the switch.
The syntax for this command is:
show port redundancy
Example:
P130-N> show port redundancy
Redundancy Name Primary Port Secondary Port Status
--------------- ------------ -------------- ------
fast 1/7 2/12 enable
uplink 1/13 3/20 enable
Module number
Primary link of the redundancy scheme
Secondary link of the redundancy scheme
Name for the redundancy scheme (optional)