Set radius authentication retry-number command, Set radius authentication udp-port command – Avaya P130 User Manual

Page 121

Text mode
Original mode

Chapter 6 Avaya P130 CLI

Avaya P130 User’s Guide

107

Set radius authentication retry-number Command

Use the

set radius authentication retry-number command to set the

number of times an access request is sent when there is no response.

The syntax for this command is:
set radius authentication retry number

Set radius authentication udp-port Command

Use the

set radius authentication udp-port command to set the RFC

2138 approved UDP port number. Normally, the UDP port number should be set to
its default value of 1812. Some early implementations of the RADIUS server used
port number 1645.

The syntax for this command is:
set radius authentication server udp-port <1812|1645>

Retry number