General commands, Terminal commands, Clear screen command – Avaya P130 User Manual
Page 52: Ping command, Age 38
Chapter 6 Avaya P130 CLI
38
Avaya P130 User’s Guide
General Commands
Terminal Commands
Use the
terminal width and terminal length commands to set the width and
length of the terminal display in characters.
The syntax for this command is:
terminal {width|length} [
Clear screen Command
Use the
clear screen command to clear the current terminal display.
The syntax for this command is:
clear screen
Ping Command
Use the
ping command to send ICMP echo request packets to another node on the
network.
The syntax for this command is:
ping [host[number]]
Example:
To ping the IP number 149.49.48.1 ten times:
P130-N> ping 149.49.48.1 10
• IP Route Configuration Commands
Page 99
Page 108
Page 113
• Policy-based Networking Commands
host
Host IP address/Internet address of route destination. If missing
then the last host IP is used.
number
Number of packets to send. If missing then the last number is used