Avaya P130 - Manual (Page 82)

Chapter 6 Avaya P130 CLI
68 Avaya P130 User’s Guide
Show port auto-negotiation-flowcontrol-advertisement Command
Use the show port auto-negotiation-flowcontrol-advertisement
command to display the flow control advertisement for a Gigabit port used to
perform auto-negotiation.
The syntax for this command is:
show port auto-negotiation-flowcontrol-advertisement
[[/]]
Example:
P130-N> show port auto-negotiation-flowcontrol-advertisement
1/2
Port 1/2 advertises asym-tx-only flow control capabilities.
P130-N> show port auto-negotiation-flowcontrol-advertisement
Port 1/1 does not support this feature.
Port 1/2 does not support this feature.
Port 1/3 advertises no flow control capabilities.
etc.
Show port trap Command
Use the show port trap command to display information on SNMP generic link
up/down traps sent for a specific port.
The syntax for this command is:
show port trap [[/]]
Example:
P130-N> show port trap 1/1
Port 1/1 up/down trap is disabled
mod_num Module number
port_num Number of the port on the module
mod_num Module number
port_num Number of the port on the module