Validate-group command, Set qos policy-source command – Avaya P130 User Manual
Page 138

Chapter 6 Avaya P130 CLI
124
Avaya P130 User’s Guide
Validate-group Command
Use the
validate-group command to verify that all the rules in a priority list are
valid.
If there is a configuration problem with a specific rule, or with a number of rules,
detailed error messages will be given.
The syntax for this command is:
validate-group
Example:
P130-N(super)# validate-group 101
Set qos policy-source Command
Use the
set qos policy-source command to set the policy source. The default
policy source is policy-server.
Note:
Before configuring the IP access list, you must change the policy source mode
to local.
The syntax for this command is:
set qos policy-source
Example:
P130-N(super)# set qos policy-source local
quiet
Does not display error messages
local | policy-server