Avaya P130 - Manual (Page 80)

Chapter 6 Avaya P130 CLI
66 Avaya P130 User’s Guide
Port Commands
Show port Command
Use the show port command to display port status.
The syntax for this command is:
P130-N> show port [mod_num[/port_num]]
Example:
To display the status for port 4 on module 1:
P130-N> show port 1/4
Port Name Status VLAN Level Neg Dup. Spd. Type
---- ----- ------ ----- ------ ----- ---- ------ ------
1/4 NoName disabled 203 normal enable full 100M 100BaseT
Show Port Output Fields:
mod_num Module number (optional). If you do not specify a
number, the ports on all modules are shown.
port_num Number of the port on the module (optional). If you
do not specify a number, all the ports on the module
are shown.
Field Description
Port Module and port number
Name Name of the port
Status Status of the port (connected, faulty, disabled)
VLAN VLAN ID of the port
Level Priority level of the port (normal or high)
Neg The negotiation status of the port (enable, disable)
Duplex Duplex setting for the port (fdx, hdx)
Speed Speed setting for the port (10, 100, 1000)
Type Port type, for example, 10/100BaseTX, GBIC_SX,
GBIC_LX, GBIC_not present, GBIC_unknown, 1000Base-
T