Alpha Technologies XM3-HP Series - Technical Manual - Manual (Page 53)

53 017-882-B0-001 Rev. C2 (10/2013)
2.0
Installation
Use the following procedure to configure a static IP
address on a laptop or computer with the Windows XP
operating system:
1. Click the Start button (lower left button on most
Windows ® computers).
2. When the window pops up, click Control Panel
(usually about half the way down the second
column).
3. Click Network Connections.
4. Right-Click Local Area Connection link to open
menu box.
5. Click the bottom option Properties.
6. You will see a dialog box much like Fig. 2-30;
select Internet Protocol (TCP/IP) and then click
the Properties button.
7. The Internet Protocol (TCP/IP) Properties dialog
box will open (Fig. 2-31). Select "Use the following
IP address". Enter the values as shown (i.e.
IP address 192.168.100.2 and Subnet mask
255.255.255.0). Record the existing IP address
and Subnet mask in order to later return the
computer to its original state.
8. Click the OK button and try to connect to the
DSM3 Series transponder once again using
192.168.100.1 in your Web browser.
9. To restore network settings, repeat Steps 1
through 6.
If you are unable to view the home page of the DSM3 Series using IP address 192.168.100.1, the
network configuration on the computer that is being used to connect to the DSM3 Series transponder may
require a temporary static IP address to be configured.
NOTE:
Fig. 2-30, Local Area Connection
Properties Screen, Windows XP
Fig. 2-31, Internet Protocol (TCP/IP)
Properties Screen, Windows XP
2.2.10.1 Local Web Server Access, continued
2.2 XM3-HP Start-Up Procedure, continued
2.2.10 Web Interface, continued
2.0 Installation, continued