Alpha Technologies XM3-HP Series - Technical Manual - Manual (Page 37)

37 017-882-B0-001 Rev. C2 (10/2013)
2.0
Installation
2.1.1 Pre-installation Inspection
1. Remove the Power Supply from the shipping container. Confirm the Power Supply, including
the Precision Temperature Sensor and all other ordered options, are included.
2. During shipping, components might shift. Carefully inspect the Power Supply and other contents
for possible shipping-related failures, such as loosened or damaged connectors. If any items
are damaged or missing, contact Alpha Technologies or the shipping company immediately.
Most shipping companies have a short claim period.
3. Do not attempt to install a Power Supply without first passing a complete pre-installation
inspection.
Read the Safety Precautions, Utility Power Connection Notes and Grounding Connection Notes (pages
9-15) before installing the Power Supply.
Use the original shipping container if the Power Supply needs to be returned for service. If the original container is
not available, make sure the unit is well packed with at least three inches of shock-absorbing material to prevent
shipping damage.
NOTE:
CAUTION!
Do not use popcorn-type material. Alpha Technologies is not responsible for damage caused by
improper packaging of returned units.
CAUTION!
2.1 Installation Procedure
The Alpha XM3-HP CableUPS can be shelf-mounted within a variety of Alpha enclosures and secured with an
internal tamper-resistant security screw kit. The installer must read and follow all safety instructions starting
on page 9 and the preliminary inspection below prior to installation of the Power Supply.
2.0 Installation
2.1.2 Internal Security Screw Kit Installation
The security screw kit included with the XM3-HP Power Supply provides the hardware for
securing the power supply to its enclosure. The security key for the included security screw is
NOT in the installation kit and must be purchased separately from Alpha. The customer may
supply their own tamper resistant/security fastener if desired.
• Only qualified service personnel should perform this procedure.
• Use
EXTREME CAUTION when drilling into the enclosure. Clear all equipment, wiring, and
batteries from the area into which you are drilling.
• Lead-acid batteries contain dangerous voltages, currents and corrosive material.
WARNING!
Required Materials:
• Security Screw Kit, p/n 746-316-20
• Alpha-01 Security Key, p/n 647-188-10
• 3/8" Hand Drill
• 13/32" (#Y) Drill Bit
• Center Punch
• 3/8" Socket and Torque Wrench
• This security enhancement is available on the XM3-HP with a manufacturing code of 2013 and newer.
• Enclosure and Power Supply unit may differ slightly from the figures. Use as reference only.
NOTE: