Alpha Technologies XM3-HP Series - Technical Manual User Manual

Page 3

Technical Manual

017-882-B0-001, Rev. C2

Effective Date: October 2013

Photographs contained in this manual are for illustrative purposes only. These photographs may not match your

installation.

Operator is cautioned to review the drawings and illustrations contained in this manual before proceeding. If there

are questions regarding the safe operation of this powering system, please contact Alpha Technologies or your

nearest Alpha representative.

Alpha shall not be held liable for any damage or injury involving its enclosures, power supplies, generators,

batteries or other hardware if used or operated in any manner or subject to any condition not consistent with its

intended purpose or is installed or operated in an unapproved manner or improperly maintained.

Notice of FCC Compliance

Per FCC 47 CFR 15.21:

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to

operate the equipment.

Per FCC 47 CFR 15.105:

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the

FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment

is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if

not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required

to correct the interference at their own expense.

Contacting Alpha Technologies: www.alpha.com

For general product information and customer service (7 AM to 5 PM, Pacific Time), call

1-800-863-3930

For complete technical support, call

1-800-863-3364

7 AM to 5 PM, Pacific Time or 24/7 emergency support

NOTE: