Franklin Fueling Systems Tank Sentinel (TS-1001, 2001, 504, & 508) Setup Programming Guide - Manual (Page 24)

Tank Setup Page 2 - 1 2
2 Tanks SETUP PROGRAMMING
Tanks Menu
H U
MENU
×
Press this key and follow the
7 highlighted sequence below
Contents:
Tank Data Menu
Tank Alarm Menu
Special Tank Menu
Worksheet 2-1, 2-2
Tank Output Groups
NOTE
☞
See the Table of Contents to find topics
in this manual. See the Preface for
general information about this manual.
See the Installation, Operator’s,
TroubleShooting Guides and Application
Notes for other reference sources.
Only the NO. (of) TANKS set under the
system menu are shown here !
Remember:
• Use ▲ UP or DOWN ▼ keys to display more
menus (MORE shown) or selections (UP /
DN are shown)
• Press CANCEL to cancel data entry
• Use the ENTER key to accept data
Character input / editing:
• Press menu keys ( M1 to M4 ) to access
menus.
• Press M4 to backspace (delete) one or more
characters to the left
ï
• Use M2 to move the cursor right
ð
• Press M1 to move the cursor left
ï
TANK DATA N refers to / represents a tank number
TANK 1 TANK 2 ...... Select the tank number to program Data.
TANK DATA N Tank 1 is shown selected (press M1 key).
COPY
COPY FROM TANK DATA X TO N
TANK 1 Select a tank to copy data from (use M key).
COPY FROM TANK DATA N TO N
PRESS ENTER IF YOU ARE SURE?
Press ENTER to accept this data.
Use UP / DOWN ▲▼ keys to display tanks 5-8.
SELECT MENU OPTION
SETUP UPGRADE LANGUAGE DATALOG
M1 M2 M3 M4
SETUP MENU (MORE)
EXIT SYSTEM TANKS PROBES
M1 M2 M3 M4
TANKS
DATA ALARMS S P E C I A L
M1 M2 M3 M4