Franklin Fueling Systems Tank Sentinel (TS-1001, 2001, 504, & 508) Setup Programming Guide - Manual (Page 16)

P Page P - viii Tank Sentinel Setup Programming Guide
Leaving (Exit) Setup Programming
There are two ways to leave the setup mode. These are:
1.) Use (press) the CANCEL key until the exit choice appears, then press the M1 key to
exit the setup mode.
– or –
2.) Wait until the Tank Sentinel console autoexits .
The unit will automatically leave / exit the setup mode ( autoexit ) after three or four minutes
of inactivity (if no key is pressed). This feature prevents the unit from being left in the setup
mode for long periods of time...
leak testing and leak detection are not active while in
the setup mode.
While viewing data in the normal run mode, the display will also revert to the normal display
after shorter period of key inactivity (20 or 30 seconds).
After Programming is Done
After the system is custom-programmed and tested, printout or Fax a hard copy of the:
system setup report, and a setup report for each tank for your records. Please give a
copy of these reports to the customer for his records.
Warranty Reminder
After installation, make sure to sign the completed Warranty Registration form and
return it to INCON. This form validates the express warranty stated here !
— ❖ —
NOTE
☞
SETUP MENU (MORE)
EXIT SYSTEM TANKS PROBES
M1 M2 M3 M4